Everything about winchester primer chart
Everything about winchester primer chart
Blog Article
Though we (me?) at times poke fun and jabs at Hodgdon/IMR for saying "just use one other fellas data for the new Rainbow shotgun powders", I'd post which was almost certainly a reasonably good selection by them to complete/say that.
Would make me Feel They are really pretty hot. Truthfully I exploit cheddites for every little thing now, it’s all that’s offered. Numerous good data out there too.
This can be an more mature thread, you might not get a response, and could be reviving an old thread. Be sure to take into account making a new thread.
Perhaps it has something to accomplish Using the angled firing pins employed by in excess of/underneath shotguns. The BT-ninety nine incorporates a straight line firing pin as do most all pumps and autoloaders.
These non-corrosive, all temperature primers provide fast, trustworthy ignition under any taking pictures condition. Primers are frequently and rigorously tested for regularity and sensitivity at temperatures and problems considerably beyond the range of usual use.
Not so new member aged aka in advance of moving to KY was Ohio Wildfowler ( used to be a moderator on a couple forums)
The brand new Hodgdon Clays family is a wonderful example of that, - it won't even look like the aged Clays.
The sole suggestions I give on which that you are entitled to depend is usually that which I am qualified to give and for which you've got paid out me. Abide by all other advice at your own chance.
Do what you think that is best, but loads of us will no more use them or even the Nobel Sport primers for that cause.
My suggestion for yourself together with the rest of the trolls that stop by below, is to seek out another thing to try and do with your time and efforts. Most likely knitting is true up your ally?
I just hope I did not waste 300 hulls for this examination for a buddy. I've sufficient of cheddite's to last me numerous many years, the W209's were just for a test. I will not be shopping for any if/if they arrive available.
I'm managing a MEC9000GN on an Automate. I am able to begin winchester primers wlp to see the .005" additional thickness leading to troubles with rotation, but I can't see what on earth is triggering the bulge.
Increase to quote Only exhibit this user #13 · Jun 23, 2009 You should use the Cheddites, BUT they don't interchange "straight" for another primer. There is a wide range of data on the market and this subject matter has been rehashed on this Discussion board many times more than. I might propose being away from any load that commences out in close proximity to or over ten,000 PSI and dropping the powder cost a fifty percent grain or so.
dogchaser37 mentioned: I feel that all this second guessing and tests of Earlier revealed data is generating people to chase 'ghosts'. Click on to increase...